Submit A Question about детектор протокола для обнаружения последних прорывов OBDII
Questions and Answers about (Item No. SO221B)
Question 1: by Daniel Boulanger May 21, 2019
Good day,
Based on some feedback I viewed on Youtube, it seems that there is a problem with the CANH and CANL (#6 and #14) where the corresponding leds aren't blinking as they should even if there is a signal.
One viewer in particular suggested to change the 1K resistors for 10K resistors to correct the problem.
Is someone aware of that problem ?
Obviously, the same situation could apply to other signals but it hasn't been confirmed.
Also, someone mentioned that the voltmeter wasn't working.
Is there a schematic available to troubleshoot such problems ? Knowing that the signals are fine but the box indicators aren't showing the proper status, there must be something that need to be looked at.
Regards.
Based on some feedback I viewed on Youtube, it seems that there is a problem with the CANH and CANL (#6 and #14) where the corresponding leds aren't blinking as they should even if there is a signal.
One viewer in particular suggested to change the 1K resistors for 10K resistors to correct the problem.
Is someone aware of that problem ?
Obviously, the same situation could apply to other signals but it hasn't been confirmed.
Also, someone mentioned that the voltmeter wasn't working.
Is there a schematic available to troubleshoot such problems ? Knowing that the signals are fine but the box indicators aren't showing the proper status, there must be something that need to be looked at.
Regards.
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece
- US$0.00 / piece